Aluminium extrusion technology
Aluminium extrusion technology, engineered end to end.
Extrusion presses, billet and container heating, coated dies, nitrogen die cooling, run-out systems and plant-wide software—specialist European technologies, engineered into one complete solution and supported in India.
Solution partners
What we supply
Specialist technologies. One integrated extrusion line.
Each stage is supplied by a specialist European manufacturer. Alumaan brings these technologies together, coordinates the complete specification and provides local installation and support—so every part of your extrusion line works as one system.
CVD-coated extrusion dies
WEFA
Precision extrusion dies for complex profiles, thin walls and tight tolerances—with advanced CVD coating for longer die life, consistent profile quality and reduced maintenance by eliminating the nitriding process altogether.
Read more
Billet and log heating
Extrutec
Complete billet and log heating solutions—from gas-fired rapid-heating furnaces and electrically heated high-convection systems to induction and patented inline hybrid technology—engineered for reproducible billet temperatures, precise taper control and efficient energy use.
Read more
Container heating
MARX
The MARX Smart Container integrates multi-zone resistance-heating cartridges directly into the extrusion container for a homogeneous temperature profile and reduced thermal stress.
Read more
Extrusion management software
Atie Uno
One connected ecosystem for the entire extrusion plant—feasibility, planning, press control, quality, logistics and performance analysis through a modular EMS.
Read more
Run-out and handling lines
Unterschütz
Custom-built run-out and handling, from puller and hot saw through to packaging, engineered as one automated line.
Read more
Surface finishing lines
Santioli
Finishing lines for sheet and coil, from brushing through to mirror, with two-minute changeovers.
Read more
Why this equipment
Numbers the manufacturers stand behind.
These are the figures that decide a business case: heating efficiency, software depth, and how long the finishing line stays down between finishes.
- Heating efficiency on Extrutec billet-heating systems.
- 96%Heating efficiency on Extrutec billet-heating systems.
- Thermal efficiency of the EHKO electric high-convection furnace.
- 87%Thermal efficiency of the EHKO electric high-convection furnace.
- Dedicated to aluminium extrusion software.
- 40 yrsDedicated to aluminium extrusion software.
- Belt and roll changeover on the finishing line.
- 2 minBelt and roll changeover on the finishing line.
Services
The equipment is half the job.
A press that arrives without a layout, trained operators or a commissioning plan is a very expensive delay. We cover the work either side of the delivery.
- Equipment layout design
- Plant layouts that put the press, handling and auxiliary equipment where the material flow wants them, sized to your throughput target rather than a catalogue footprint.
- Press and auxiliary selection
- Specification of the press and the equipment around it — handling, quench, puller, stretcher, saw — against your alloy mix, section range and shift pattern.
- Die shop equipment
- Nitriding, cleaning, correction and inspection equipment scaled to the die population your press will actually consume.
- Erection and commissioning
- Installation supervision and commissioning through to first good profile, coordinated with the manufacturer's engineers.
- Recruitment support
- A structured hiring programme for press, die shop and maintenance roles, so trained people are in place before the line runs.
- Utilisation and recovery estimation
- Realistic modelling of press utilisation and metal recovery, used to test a business case before capital is committed.
Who you deal with
Twenty years of extrusion, one phone number.
Alumaan was founded in 2024 by Mehul Raval, after eighteen years in induction heating and European extrusion equipment. The person who scopes your plant is the person who answers when something on it needs attention.
Tell us what you are building.
A new line, a press upgrade, or a heating stage that is costing you more than it should. Send us the details and we will come back with a specification, not a brochure.